NTPC  Placement Paper   Whole Testpaper   -01 May 2010

NTPC  Placement Paper   Whole Testpaper   -01 May 2010


  • Posted by  FreshersWorld 
    7 Jan, 2012

    Hi everybody !

     
    The below are few questions which were asked in the Written test of NTPC 2010 .( Category - Mechanical Eng.)
     
    A 2 hour test for 85 questions , 50 - Technical & rest are general Aptitude, ( negative marking of 1/4 will be deducted) .
     
    Part - 1 , ( Technical)
     
    1. What is ABC Analysis? - Inventory cost management
    2. What is farenheit 9 / 11 ? - A Micheal More,s Documentary film of 2004. They confused it other options like unit of temp, device used to count the no of cells in body etc..
    3. What is Kaplan Turbine - A high head low discharge , Low head high discharge etc were the options.
    4. Chip formation occurs during which of the following conditions :
     
    a) High speed low rake angle
    b) Low speed High rake angle
    c) Low Low
    d) High High
     
    5. What is centrifugal Pump?
    6. Problems related to Speed of the Flywheel?
    7. Booting Information is stored in:
     
    a) RAM  b) ROM c) EPROM d) PROM
     
    8. C 177 S - 6 denotes which type of fit? Options were clearance fit , Running Fit, Push Fit etc
     
    9. Pre heating in welding is done for ?? - To prevent Cold cracks
     
    10. Precautionary measures used in Welding?
    11. Problems on Efficiency of rankine cycle?
    12. Hook,s law MOSTLY applies for which of these materials? - Rubber , Plastic, carbon steel , Tungsten.
    13.When does Break Even Point occur?
    14. What is meant by Discretionary cost? 
    15 .Methods to improve efficiency of heat Exchanger?
    16. NGL interferometer is used for??? ( A question from metrology)
    17. problems on Emissivity?
     
    Part - 2
     
    1. How do you Identify Cristiano Ronaldo?
     
    2. Few questions on the following:
    a) Comprehensive passage reading,
    b) Bar chart interpretation
    c) Missing no,s in a series
    d) Coding of alphabets
    e) Permutation & combination
    f) Gramatically Correcting a sentence
    g) Arranging the bits of sentences in proper order which forms a meaningful story
    h) Diagrams from the options which follows a particular sequence
     
    These are just a few which i remember as i write. On an overall , It was an easy job for the mind. But No doubt the Cut off for qualifying would be high.
     
    Good Luck to the next batch who take up !
     
    Regards
     
    Prashanth
    +91 99406 18891
    Chennai
     
     
         

2009-2016 downloadmela.com. All rights reserved.