Jindal  Placement Paper   Candidate Experiences   Bhopal-21 Nov 2010

Jindal  Placement Paper   Candidate Experiences   Bhopal-21 Nov 2010


  • Posted by  FreshersWorld 
    7 Jan, 2012

    Hello Friends,


    I'm Himanshu Shekhar Kashyap from OIST, Bhopal. I'm a student of Mechanical department. Final year and i appeared for Jindal steel GET 2010 recruitment.  I'm waitng for my result. I will be glad if readers find this article helpful, and i would advice you 2 post your experiences here.

    In written test there are 115 questions. (60 tech+20 verbal+20 quantitative+15 reasoning)
    Out of 60 core auest (20 are from SOM+4 vibration+2TOM+2 material SCI+5HMT reynolds, biot etc. Num+2centrifugal pupp+5 4m FLUID+1 governor mainly SOM, TOM, DOM.)

    But Be careful. They can ask more questions from production Engineering as in 2009.
    So prepare well.(Production and som series)

    Non Technical (2 RC 10 questions+Adjective+Prepos.+Word meaning)
    Quantitative very easy (Ratio+Time and work+Simple & Componed Interest+Alligation+Percentage+Pipe mostly from these topics)

    Reasong section was very easy like.
    ttjjy3tg44, ttjjz3tg44, ttjjy3tg44. Which are alikes. (3 questions are like this)

    If + means *,- means /,*means  + than find the value of 23+18-3*24(4 questions are like this.)
    7737888812328745. Find the no. of seven which have 8 as its successor and 3 as its pred. (3 questions are like this)

    Some technical questions are.
    1. Reynolds numer is?

    2. Biot number is used for solid or liquid?

    3. Shear stress on principl plane is?

    4 T time of flight in projectile motion is?

    5. Velocity of a body while ascending will be more or less than the velocity while decnding?

    6. Boundary separation wil occur when press.gradient will?

    7. Elongation in tapered bar will be formula?

    8. Small numerical on parallel flow heat exchanger.

    9. Relation b/w poissions ratio and young modulus.

    10. Grashoof number expression.

    11. Expression of torque in hollow and solid shaft.(2 questions)

    12. Hardness and tensile stength can be increased by which process?

    13. If load will be increased on free end of cantiliver beam than it wil break 4m fixed or free end?

    14. Tension on tight side side of rope drive will be?

    15. Coefficient of fluctuation of speed in governor will be formula?

    16. Geneva mechanism will be used in?

    17. Double pn junction is used in rectifier, transtitor, photovoltaic call?

    18. If the velocity of a body on 2 different points on radius of a circle are given than find the radius of that circle?

    19. Gear ratio is define as?

    20. Bearing is made up of material for carrying high load?

    Since no questions ard from welding, casting, maching, metrology in 2010. It does not mean they will not ask much questions from these topics in next year. They can like in 2009. So prepare all the topics(Stress can be given on production and SOM series)

    All the best!

2009-2016 downloadmela.com. All rights reserved.