HAL  Placement Paper   Technical - Other   Hyderabad-25 Nov 2006

HAL  Placement Paper   Technical - Other   Hyderabad-25 Nov 2006


  • Posted by  FreshersWorld 
    7 Jan, 2012

     

    HAL PAPER ON 26th NOVEMBER AT HYDERABAD
     

    Hai friends,,
    Here are the some of the technical questions posed in the HAL exam for the post of Management/Design Trainee on 26-11-2006 for electrical branch.

     1) What is the distance between the EHV lines?
         a)8m     b)11m     c)4m    d)14m

     2) At present how many HVDC lines are there in india?
         a)none   b)one      c)two    d)more than two

     3) Where is the nuclear located in following places?
          ans: i dont remember the answers, but one of them is thalcher(orissa)

     4) What is the approximate peak overshoot for a unity feedback system with damping factor 0.6?
         a)10%   b)5%      c)15%    d)20%

     5) What is the distance between the EHV lines and earth?
         a)8m   b)11m       c)18m     d)15m

     6) On no load in EHV lines what is the relation between receinving  and sending end voltage?
         ans: receiving end voltage > sending end voltage

     7) What is the surge impedance loading of 400kv line?
         ans:   4002/400ohms =400watts

     8) similar question with surge impedance given as 160 ohms
         ans:   1000watts

     9) If both the juctions of transistor are forward biased, in wat region transistor works
         ans: saturation region

    10) Where is the hydel power plant located in following places?
         ans: I dont remember the places

    11) self GMD is used in the calculation of_______
      a) inductance only
      b) inductance and capacitance
      c) capacitance only
      d) none

    12) What is the GMD if the distance between the lines are 6m,6m,12m?
           ans: 7.058m( approx)

    13) Zero sequence currents doesn't exist in the following fault
      a) L-G
      b) L-L
      c) L-L-G
      d) L-L-L-G
        Ans:  d

    14) To avoid arcing connect sutable value of ________ in earthing.
      a) capacitance
      b) indunctance
      c) resistance
      d) susceptance

    15)There are two to three questions based on Laplace and Inverse Laplace transforms

    16)In the following type of conductors the corona is minimum
      a) circular
      b) stranded
      c) helical
      d) rectamgular
           ans: c

    17)When do two wattmeters show same value of opposite readings in two wattmeter method
      a) 300 lag
      b) 600 lag
      c) between 600 and 900 lag
      d) zpf lag
          ans: d

    18) Schering bridge is used to measure
      a) frequency
      b) inductance
      c) capacitance
      d) mutual inductance
          and:  c

    19) What is the value of resistance when both length and diameter of the wire are doubled?
         ans: halved

    20) There is one questions asked on euler's formula..

    21) What is the Laplace transform of unit ramp signal?
           ans:1/s2

    22) What happens to the value of inductance when self GMD is doubled?

    23) At what frequency corona loss is more?
      a) 50Hz
      b) 60Hz
      c)
      d)

    24) What is the largest rating of alternator manufactured in india?
      a) 1000MW
      b) 500MW
      c) 1200MW
      d) 250MW 
           ans:b                               

    25) The response of an RLC circuit for impuse input?
      a) exponentially raising
      b) sinusoidal
      c) exponential falling
      d) parabolic
          ans: c

    26) What is the easier method for finding no. of poles in the right half of s-plane?
      a) Niquist plot
      b) R-H criterion
      c) Root-Locus method
      d) Polor plot
        ans: b

    27) How many no of poles located in the right half of s-plane for the characteristic equation...

    28) Burden of current transformers is measured in..
      a) Watts
      b) Volt Amperes

      c) Ampere Hours
      d) Joules
     
    29)What is the gate used to get high output when all the inputs are low?
      a) NOR
      b) NAND
      c) Ex-OR
      d) Ex-NOR
        ans: b
     
    30) Large no of thyristors are used in HVDC transmission to improve______
      a) current rating
      b) voltage rating
      c) Thyristers are available at high ratings
      d)
     
    31) What is the line current of a circuit when the current transformer of 1000:5 rating measures 4Amperes?
          ans: 800A
     
    32) If the time delay of relay with TMS setting 0.1 is 10 sec, then what is the time delaty when the TMS setting is changed to 0.5
     
    33) How many no of flip-flops are required to get 16 bit counter?
     
    34) _________is connected to reduce frequency errors in ammeter.
      a) shunt capacitor
      b) series inductance
      c) shunt inductance
      d)
     
    35)What is the value of ripple factor in Half Wave Rectifier?
      a) 1.11
      b) 0.8
      c) 1.21
      d)
     
    36)The principle used in megger?
      a) electrostatic effect
      b) magnetic effect
      c) Induction effect
      d)
     
    37)In electrodynamometer type wattmeter the error is due to..
      a) pressure coil inductance
      b) pressure coil resistance
      c)
      d)
     
    38) In the following locations where is hydal power plant is not located?
       ans:  i dont remember the places
     
    39) In distribution lines_____
      a) X/R<0.1
      b) X/R>10
      c) X/R>1
      d) X/R<0.01
     
    40) In EHV lines _____
      a) X/R=10
      b) X/R=100
      c)
      d)
     
    41) What is the speed of 2 pole alternator at 50Hz frequency?
           ans: 3000rpm
     
    42) What is the equivalent decimal no of (624)8
     
    43) What is the binary equivalent of 6.25
     
    44) What is the value of A+AB+B¯  ( B bar)
           ans: 1
     
    45) What are the avg and rms values of full wave rectifier
          ans: 2Vm/pie, Vm/21/2
     
    46) There is one question based on rank of matrix
     
    47) What is the equivalent of cos(wt+18.750)
      a) sin(wt+71.250)
      b) sin(wt-71.250)
      c) sin(wt+18.250)
      d) sin(wt-18.250)
     
    48) The three harmonics will be in phace with each other?_____
      a) 3,5,15
      b) 2,4,6
      c)
      d) 
          ans:  a
     
    49) The line current  will be equal to phase current in______
        ans: delta connection
     
    50) In windmills the frequent problems occur in______
      a) mechanical system
      b) blades
      c) electrodynamic system
      d) electric system
     
    51) The machine used in windmills is______
      a) alternator
      b) induction generator
      c)
      d) 
        ans: b
     
    52) Insulators in EHV lines are designed based on_____
      a) switching voltages
      b) peak voltages
      c) corona
      d) lightning voltages
       ans:  a
     
    53) The value of restriking voltage depends on______
       a) inductance of line
       b) capacitance of line
       c) both
       d) none
                                                                                      *****ALL THE BEST*****

    Regards,
    Prashanth Tirungari

2009-2016 downloadmela.com. All rights reserved.